Note: CuboAi Smart Temp is currently only available for purchase in Taiwan, Hong Kong, Macau, the United States, Australia, the United Kingdom, Germany and France.
💡"CuboAi Smart Temp" is not compatible with CuboAi(Gen1).
💡Please ensure that both the firmware version and CuboAi app are up to date.
Power on：Press and hold the button on the Smart Temp and wait for the power indicator light on the bottom right corner to flash green.
Power off：Press and hold the button for about 4 seconds; the battery indicator light on the bottom right corner will flash orange twice then stop flashing. The device has been switched off once there is no light.
🐦Reminder:
It may take a few seconds for the Smart Temp LED to light up after the power button is pressed. Please wait and check for the LED light changes before proceeding to next steps. Additionally, please note that the power button on the Smart Temp consists of a membrane switch. Therefore, the physical feedback after pressing differs from most buttons and may require using a greater force when pressing.
If you find the button difficult to press, you may try placing the Smart Temp on a table, then use the tip of a pen cover or the edge of the charging case to press the power button with more ease.
If you have any further questions, please contact us through the following channels:
- In-App: Settings → Chat With Us
- Facebook Messenger: m.me/cubobabymonitor
- E-mail: support@cuboai.com
Comments
0 comments
Article is closed for comments.