CuboAi comes with 3 different stand options - Crib Attachment, Floor Stand, and Mobile Stand to fit your little ones’ needs during different stages of their growth. (If you have a CuboAi Plus instead, please refer to the article for CuboAi Plus.)
(1) The "Crib Attachment" is designed to attach to the spindles of Baby's crib. Note that the gap between spindles should be less than 2.7” / 7cm. CuboAi’s height can be adjusted by changing the position of the bed clamp. This saves space and can be transported with the crib for convenience.
Stand Height: 4’3” / 130cm including CuboAi 4.33” / 11cm.
Made out of a material similar in texture to a yoga mat, the clamping bed attachment slides in between two spindles of a crib, enabling the stand to fit snugly into many different sized cribs.
*Please note that crib attachment should only be used between spindles that are at most 2.7” / 7cm apart.
(2) The "Floor Stand" stands on the floor and has a tall neck (about 5 feet) on top of which CuboAi sits. This can be used when Baby grows out of their crib since it does not require attachment. The Floor Stand was designed to freely move around as needed. Once assembled, the Floor Stand base can be slid under the crib.
Stand Height: 5’4” / 163cm including CuboAi (4.33” / 11cm)
Base Diameter: 11.4” / 29cm
Base Height: 2.16” / 5.5cm
(3) The "Mobile Stand" is a small docking station for CuboAi attached to a ~7 ft. (200cm) long cord. This stand is designed for when you're on the go, whether you’re traveling or just want to set up in a different room of the house. This mobile stand also turns CuboAi into a toddler cam when your little one starts crawling or walking around the house!
Comments
0 comments
Article is closed for comments.